HYRENE TS PARKING Process
Waterproofing process with two-layer bitumen membranes under concrete slab for car park flat roofs.
The two-layer composed of HYRENE TS PY grésé + HYRENE 25/25 TS is welded full on ANTAC varnish or laid independently (MAT 100) depending on the type of concrete load-bearing element (full adhesion forbidden on type D or type A supporting element with structural floor tray).
Accessible to pedestrians, light or heavy vehicles; possible insulation (get in touch).
- Composantes
- Atouts
- Caractéristiques
- Applications
-
1/Elément porteur béton
-
2/
-
3/
-
4/
-
5/
-
6/
-
7/Dalle béton désolidarisée
- Traditional recommended system under concrete slab.
- The vapour barriers of the ROLLSTICK range can replace the traditional vapour barrier for an insulated flat roof.
- Technical Application Document of the CSTB
- Possible insulation: cellular glass, perlite, XPS (inverted roof). Get in touch.
- Basic solution: EIF + HYRENE TS CPV grésé + HYRENE 25/25 TS fully welded if the load-bearing element allows it.
- In a mountain climate: HYRENE TS CPV grésé replaces HYRENE 25/25 TS.
- The concrete slab is poured onto a separation layer suitable for circulation. The protection must comply with the DTU; the separation layer may either be traditional or pre-fabricated (e.g. DELTA TERRAXX). Get in touch.
- Ideally, the two-layer solution should be fully welded if the load-bearing element allows it.
Advice & technical assistance Tell us about your project
You may also be interested in these products
Warning: Invalid argument supplied for foreach() in /home/hrhkqbh/www/wp-content/themes/axter/single-produit.php on line 430
Use our step-by-step guide to find the right solution
Try our tool to help you choose
